Jennair RISE JUIFX15HX Instructions D'installation

for JennAir
Use the materials in this accessory kit to install the RISE™
stainless steel panel by following the installation instructions.
Before you begin:
A qualified service technician must perform installation.
Panel Accessory contains:
1. Front Panel and Handle Assembly
2. Screws (2)— #8-15 X .813 HW A
Tools required:
1. Phillips Screwdriver
2. Flat Head Screwdriver
3. Diagonal Cutting Plier
Installation Procedure
1. Remove the screws attaching hinge covers using the flat
head screwdriver.
2. Remove the hinge cover from upper and lower hinges.
A. Upper hinge cover
B. Lower hinge cover
3. To remove, cut hinge cover at indicated point using diagonal
cutting plier and remove from hinges.
INSTALLATION INSTRUCTIONS
Ice Maker RISE™ Stainless Steel Panel Accessory
®
A
B
4. Remove screws (3) from the top and bottom metal brackets
using the Phillips screwdriver. Remove and discard metal
brackets and holding screws.
5. Slide new front panel assembly on the Ice Maker door from
the top.
1