Using The Software - Analog way VIO 1600 Manuel Utilisateur

VIO1600 & ULTRA VIO
6-3. COMMUNICATION SETUP (continued)
• CASE OF LAN PORT:
- With the front panel display menu of the device, verify the configuration of the LAN communication port
(CONTROL > LAN setup), then activate the LAN communication port (CONTROL > RS232/LAN port >
LAN).
- With the Controls menu of the software, select RS232/LAN setup and LAN Setup. Then configure the Local
port, the Remote IP address and the Remote port and click on Apply to setup the new values. The software will
also display Device connected.
NOTE: To verify the LAN status of your device: Select LAN status in the Controls menu.

6-4. USING THE SOFTWARE

Click on the Input tab and select the Signal Type for each input. Then make the others adjustments (video
Standard...) and disable the unused inputs (Used section).
Chapter 6 : REMOTE CONTROL SOFTWARE (continued)
PAGE 27