Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
STUDIO SCAN XTD825 / 625™
Chapter 9 : CONTROL SOFTWARE
9-1. CONNECTION
• CONNECTING THE RS-232:
Connect the serial port of your control device to the REMOTE CONTROL (RS-232) connector (DB 9 Female) of the
STUDIO SCAN XTD825 / 625
• PIN-OUT:
PIN #
2
3
5
(Rear panel of the STUDIO SCAN XTD825 / 625
• SPEED TRANSMISSION: 9600 bauds, 8 data bits, 1 stop bit, no parity bit, no flow control.
9-2. "STUDIO SCAN XTD825 / 625 REMOTE CONTROL" SOFTWARE
Your device is shipped with a Windows compatible Remote Control Software. This software allows you to control and
make all adjustments by a simple mouse click.
• SOFTWARE INSTALLATION:
Turn your computer ON and wait for Windows to completely start.
Insert the CD-ROM into your drive: the ANALOG WAY home window will open automatically.
Select the language of the CD-ROM menus, then click on "Install a Remote Control Software" and select the name
of your device.
IMPORTANT: If the Autorun is not enabled: From the Windows desktop, open My Computer and select the CD-
Follow the Windows installation instructions.
• COMMUNICATION SETUP:
Connect the RS-232 cables between the control device and the STUDIO SCAN XTD825 / 625
section 9-1.
Then only power ON all of the devices.
Click on the program files XTD825-625 in Start-program-ANALOGWAY-STUDIO SCAN to run the software.
Click on Controls menu and select the Serial port.
The STUDIO SCAN XTD825 / 625
™
with a straight cable (DB 9 Female / DB 9 Male).
FUNCTIONS
TRANSMIT DATA (Tx)
RECEIVE DATA (Rx)
GROUND (Gnd)
DB 9 female
ROM drive. Select the Autorun folder, then select the autorun.exe file.
™
is now controllable by the computer.
™
)
™
as indicated in
PAGE 17
Publicité
Table des Matières
