Before Use; Inserting The Battery - Hilti SF 10W-A18 Mode D'emploi

Power tool
Drilling diameter range in wood
(soft)
B 18/1.6
Battery
Li­Ion
Rated volt- 21.6 V
age
Capacity 1.6 Ah
Weight 0.48 kg
(1.06 lb)

5 Before use

5.1 Charging a previously used battery
Ensure that the outer surfaces of the battery are clean and dry before
inserting the battery in the corresponding charger.
Read the operating instructions for the charger for further information about
the charging procedure.

5.2 Inserting the battery

CAUTION
Before fitting the battery, check that the power tool is switched off and
that the safety lock is engaged (forward/reverse switch in the middle
position). Use only the Hilti batteries approved for use with this power
tool.
1. Push the battery into the tool from the rear as far as it will go and until it
is heard to engage with a double click.
2. CAUTION A falling battery may present a risk of injury to yourself
and others.
Check that the battery is securely seated in the tool.
5.3 Removing the battery
5.4 Fitting the side handle
1. Set the forward / reverse switch to the middle position (transport lock)
or remove the battery from the power tool.
2. Release the side handle clamping band by turning the handle counter-
clockwise.
Printed: 15.04.2015 | Doc-Nr: PUB / 5161673 / 000 / 04
SF 10W-A18
1.5...50 mm (¹⁄₁₆...2")
B 18/2.6 B 18/3.3
Li­Ion (02) Li­Ion
21.6 V 21.6 V
2.6 Ah 3.3 Ah
0.48 kg 0.78 kg
(1.06 lb) (1.72 lb)
2
3
B 18/5.2
Li­Ion (01)
en
21.6 V
5.2 Ah
0.78 kg
(1.72 lb)
11