Hilti SF 10W-A18 Mode D'emploi page 17

6.2 Adjusting the side handle
1. Release the side handle clamping band by turning the handle counter-
clockwise.
2. Pivot the side handle into the desired position.
3. Tighten the side handle by turning the handle clockwise.
4. Check that the side handle holds securely.
6.3 Speed selection using the four-speed gear selector
NOTE
The mechanical four-speed gear selector can be used to select the speed
range required. Please refer to the illustration for the individual gear settings.
The stated speeds under no load will be achieved only with a fully-charged
battery.
6.4 Switching on / off
Speed of rotation can be controlled smoothly up to maximum speed by
pressing the control switch slowly.
6.5 Fitting the drill bit
1. Set the forward / reverse switch to the middle position or remove the
battery from the power tool.
2. Check that the connection end of the drill bit is clean. Clean the
connection end if necessary.
3. Insert the drill bit in the keyless chuck and then turn the chuck firmly by
hand until several clicks are heard.
4. Check that the drill bit is held securely.
6.6 Removing the drill bit
1. Set the forward / reverse switch to the middle position or remove the
battery from the power tool.
2. Open the keyless chuck.
3. Pull the insert tool out of the chuck.
6.7 Drilling
CAUTION
Use clamps or a vice to secure the workpiece. The workpiece is thus
held more securely than by hand and both hands remain free to operate
the power tool.
1. Turn the torque and operating mode setting ring to the drilling symbol.
2. Move the forward / reverse switch to the "Forward" position.
Printed: 15.04.2015 | Doc-Nr: PUB / 5161673 / 000 / 04
5
en
6
13