Operation - Hilti SF 10W-A18 Mode D'emploi

3. Slide the side handle clamping band over the chuck and onto the
clamping section at the front end of the power tool.
4. Pivot the side handle into the desired position.
5. Secure the side handle by turning the handle clockwise.
6. Check that the side handle holds securely.
en
5.5 Transport and storage of batteries
CAUTION
Fire hazard. Never transport batteries in loose, bulk form. There is a risk of
short circuiting.
Pull the battery out of the locked position (working position) and move it into
the first latching position (transport position).
Observe national and international transport regulations when shipping
batteries (transportation by road, rail, sea or air).

6 Operation

CAUTION
Working on the material may cause it to splinter. Wear eye protection and
protective gloves. Wear breathing protection if no dust removal system
is used. Splintering material presents a risk of injury to the eyes and body.
CAUTION
The tool may get hot during use. Wear protective gloves.
CAUTION
When drilling and screwdriving, the grip of the tool may be deflected
laterally (the tool tends to pivot about its own axis). Always use the
power tool with the side handle fitted and hold it securely with both
hands. Always grip the side handle at its outermost end .
CAUTION
To avoid cutting or burning injuries caused by the insert tool, wear
protective gloves when changing insert tools.
6.1 Setting forward or reverse rotation
NOTE
The forward / reverse switch is used to select the direction of rotation of the
drive spindle. An interlock prevents switching while the motor is running.
The control switch is locked when the forward / reverse switch is in the
middle position. Push the forward / reverse switch to the right (when the
power tool is held in the working direction) to select reverse rotation. Push
the forward / reverse switch to the left (when the power tool is held in the
working direction) to select forward rotation.
12
Printed: 15.04.2015 | Doc-Nr: PUB / 5161673 / 000 / 04
4