Care And Maintenance - Hilti SF 10W-A18 Mode D'emploi

6.8 Screwdriving
6.8.1 Fitting the bit holder / bit
1. Set the forward / reverse switch to the middle position or remove the
battery from the power tool.
2. Open the keyless chuck.
en
3. Insert the bit adapter in the keyless chuck and then turn the chuck firmly
by hand until tight.
4. Check that the bit adapter is held securely (check by pulling).
5. Fit the bit in the bit holder.
6.8.2 Screwdriving
1. Turn the torque, drilling and hammer drilling setting ring to the required
torque setting.
2. Set the forward / reverse switch to the desired direction of rotation.
6.8.3 Removing the bit / bit holder
1. Set the forward / reverse switch to the middle position or remove the
battery from the power tool.
2. Remove the bit from the bit holder.
3. Open the keyless chuck.
4. Remove the bit adapter.
6.9 Belt hook
CAUTION
Check that the belt hook is fitted securely before beginning work.
The belt hook allows the power tool to be attached to a belt worn by the
operator. The belt hook can also be fitted to the other side of the power tool
for use by left-handed persons.
1. Remove the battery from the power tool.
2. Fit the mounting plate into the guides provided.
3. Secure the belt hook with the two screws.

7 Care and maintenance

WARNING
Repairs to the electrical section of the power tool may be carried out
only by trained electrical specialists.
14
Printed: 15.04.2015 | Doc-Nr: PUB / 5161673 / 000 / 04
7