Adjusting The Volume; Bass Boost; Switching The 2.1 Channel Sound Bar With Wireless Subwoofer Off - Medion LIFE P69042 Mode D'emploi

 Press the LEARN button for 2 seconds in order to activate the programming
mode. A red LED on your remote control will light up.
 Press one of the TV buttons on your remote control (A); the red LED will start to
flash.
 Press the button on your TV remote (B) which you want to teach into your 2.1
sound system remote (A). If the code transmission process is successful, the red
LED will flash three times and then remain lit up. If the LED continues to flash,
this indicates that the attempt at programming has not been successful.
 Repeat the above steps in order to program further buttons.
 Press the LEARN button again to save the settings and to exit the learn mode.

6.5. Adjusting the volume

Use the + / – buttons on the loudspeaker panel or on the remote control to adjust
the volume to the required level:
• + Increase volume
• – Reduce volume
The volume can be turned off completely by pressing the MUTE button on the re-
mote control.
 Press the MUTE button again to restore the sound.

6.6. Bass boost

You can switch the bass boost on or off by pressing the RS BASS button on the re-
mote control.
 Press the RS BASS button on the remote control to turn on the bass boost. The
LED on the relevant piece of equipment will emit a slightly longer flash (about 1
to 2 seconds).
 Press the RS BASS button on the remote control to turn off the bass boost. The
LED on the relevant piece of equipment will emit a slightly shorter flash (about
0.5 to 1 second).
6.7. Switching the 2.1 Channel Sound Bar with
Wireless Subwoofer off
 Press the STANDBY button on the remote control or on the loudspeaker panel to
switch the units off.
NOTE
Mains adapters draw current even when the unit is switched off. Unplug
the 2.1 sound system at the mains in order to disconnect them from the
power supply.
72 of 76