Wand Control Buttons; Control Panel; Main Power Switch; Solution Pump Switch - Walter Surface Technologies SURFOX 104 Manuel De L'utilisateur

3
Equipment controls
C) Wand control buttons
The ON button is used to give power to the tungsten tip.
When the pumping mode is set to manual, press the ON
button to activate the pump. Press and keep the button
pressed to get continuous flow of liquid.
However, if the pumping mode is set to automatic, press
the ON button once to activate the pump. To stop the
pump, press the OFF button. When finished working
with the machine (in either mode) make sure to press
the OFF button.
Once the ON button is pressed, there will be continuous
power at the tip until the OFF button is pressed.
Tightening sleeve
Tungsten tip
Drip guard
The SURFOX 104 features a pivoting wand tip (tungsten
tip). Simply loosen the plastic tightening sleeve and turn the
tip for hard to reach places, then re-tighten the sleeve (do
not over-tighten). Do not twist more than 45° either way.
6
ON OFF
4

Control panel

Control panel
A
D
A) Main power switch
Turns the main power to the unit ON
and OFF.
B) Solution pump switch
Manual pumping mode. Choose the man-
ual pumping mode to control the amount of
solution pumping to the tip. Hold the hand
wand ON button down to pump solution to
the tip. Release the ON button to stop the
pumping cycle. Always use enough solution
to keep the cleaning pad wet. Too little solu-
tion will reduce the cleaning pad life.
Automatic pumping mode. To start the
automatic pumping mode, press the ON
button on the wand. Once it is activated,
it will automatically pump the liquid. The
quantity of liquid can be selected from less
to more. Pumping will continue in this mode
until the OFF button is pressed.
C) Indicator light
Hand wand power ON indicator. The
yellow light goes ON when the hand wand
ON button is pressed and there is power
to the tip. Power to the tip is OFF when the
hand wand OFF button is pressed.
D) Accessory outlet
Outlet for optional mini wand or
marking wand. The marking wand is used
to permanently mark your company name,
logo, part number or other desired informa-
tion onto stainless steel surfaces. The mini
wand is used to access hard to reach areas
for cleaning and passivating, which are too
small for the hand wand.
B
C