Using The Hand Wand To Clean And Passivate; Selecting The Proper Pumping Mode; Cleaning And Passivating; Neutralizing - Walter Surface Technologies SURFOX 104 Manuel De L'utilisateur

6

Using the hand wand to clean and passivate

Using the hand wand to clean and passivate
A) Selecting the proper pumping mode
Manual
mode
Manual pumping mode. Choose the manual pumping
mode to control the amount of solution pumping to the tip.
Hold the hand wand ON button down to pump solution to
the tip. Release the ON button to stop the pumping cycle.
Always use enough solution to keep the cleaning pad wet.
Automatic pumping mode. To start the automatic pump-
ing mode, press the ON button on the wand. Once it is
activated, it will automatically pump the liquid. The quantity
of liquid can be selected from less to more.
Note: It is best to use the manual mode at first, until you
become familiar with the cleaning system.
B) Cleaning and passivating
To clean and passivate, press the hand wand ON button.
Make sure the cleaning pad is saturated with SURFOX
electrolyte cleaning solution before starting to work. If the
cleaning pad is too dry, it will wear prematurely. Start work-
ing when solution drips from the cleaning pad.
Do not press hard, let the electrochemical process do the
work. Do not use the cleaning pad like an abrasive pad.
WARNING! When using the machine for the first time, there
could be water in the system from factory testing. Adjust the
liquid pump setting to automatic at maximum speed and let
the liquid drip into a disposal cup for 2 minutes (amount of
time required to empty the hose from the tank to the wand).
Then, adjust the liquid pump setting back to desired pump-
ing speed.
8
C) Neutralizing
1. Remove any excess of SURFOX electrolyte cleaning
Automatic
solution using a soft clean cloth.
mode
2. Spray SURFOX-N on the surface.
3. Wipe dry with another soft clean cloth to avoid cross
contamination.
Refer to neutralization procedure in neutralization section
for instructions on how to properly neutralize.