Using The Mini Wand (Optional) To Clean And Passivate; Manual Pumping Mode; Cleaning And Passivating; Neutralizing - Walter Surface Technologies SURFOX 104 Manuel De L'utilisateur

Using the mini wand (optional) to clean and passivate

A) Manual pumping mode
The mini wand uses a manual pumping mode only. One
(1) press equals one (1) pump. To pump more liquid, press
repeatedly. See mini wand instructions for more information.
B) Cleaning and passivating
Screw in SURFOX electro-
lyte solution 100 ml tube
onto the mini wand. Make
sure the cleaning pad is
saturated with solution
before starting to work. If
the cleaning pad is too dry,
it will wear prematurely.
Start working when solu-
tion drips from the cleaning
pad.
Do not press hard, let the
electrochemical process
do the work. The cleaning pad is a bridge between the
machine and the weld. Do not use the cleaning pad like an
abrasive pad.
C) Neutralizing
1. Remove any excess of SURFOX electrolyte cleaning
solution using a soft clean cloth.
2. Spray SURFOX-N on the surface.
3. Wipe dry with another soft clean cloth to avoid cross
contamination.
Refer to neutralization procedure in neutralization section
for instructions on how to properly neutralize.
SURFOX-H electrolyte
cleaning solution 100 ml
Part no: 54-A 011
6 per package
Use with high conductivity
cleaning pads
Using the mini wand (optional) to clean and passivate
D) List of supplies and part numbers
The mini wand kit (part no.: 54-B 034) includes:
• 1 mini wand cleaning torch
• 1 carbon fiber slow-through brush
• 1 black power cord
• 1 x 2.5 mm hex key
SURFOX-T electrolyte
cleaning solution 100 ml
Part no: 54-A 001
6 per package
Use with classic cleaning
pads and boots
7
48-R 285
54-B 029
54-B 063
Carbon fiber slow-through brush
Part no: 54-B 029
To be mounted on the mini-wand
54-B 133, use with SURFOX-H
electrolyte solution only in 100 ml
cartridges
5 per package
Ideal for tight corners, narrow
surfaces and intricate areas
User's Guide SURFOX 104
9