Assembly - DeWalt DXGP210 Manuel De L'utilisateur

INSTALLING AND REMOVING THE ATTACHMENT
The coupler enables the use of various optional attachments.
WARNING:
with the attachment. Follow all safety information contained within.
WARNING:
before removing or installing an attachment.
WARNING:
more than one extension boom to a power tool.
WARNING:
serious personal injury and damage to the unit, NEVER use the extension boom with any
other attachment.
Installing the Attachment
1. Remove the hanger cap from the attachment. Keep the hanger cap for use when storing the
attachment. If present, remove the gray spacer from the coupler.
2. Set the unit on a flat, level surface.
3. Turn the knob counterclockwise to loosen the coupler (Fig. 1).
4. Align the release button with the guide recess (Fig. 3).
5. Push the attachment straight into the coupler (Fig. 2) until the release button snaps firmly into the
primary hole (Fig. 3).
6. Turn the knob clockwise to tighten the coupler (Fig. 1).
WARNING:
into the primary hole and the knob is securely tightened.
WARNING:
the primary hole only. Using the wrong hole could lead to personal injury or damage to the
unit.
Removing the Attachment
1. Set the unit on a flat, level surface.
2. Turn the knob counterclockwise to loosen the coupler (Fig. 1).
3. Press and hold the release button (Fig. 3).
4. Pull the attachment straight out of the coupler (Fig. 2).

ASSEMBLY

Before using any attachment, read and understand the manual that came
To avoid serious personal injury and damage to the unit, shut the unit off
To avoid serious personal injury and damage to the unit, NEVER install
Only use the extention boom with the pole saw attachment. To avoid
Before operating the unit, make sure the release button is fully snapped
Unless specified otherwise, the release button should be snapped into
19