Tips For Best Results; Maintenance Schedule; Maintenance - DeWalt DXGP210 Manuel De L'utilisateur

TIPS FOR BEST RESULTS

• Follow all safety instructions. Refer to the Safety section.
• Only cut wood and materials made of wood. Do not attempt to cut sheet metal, plastics, masonry
or any other non-wood materials.
• Work slowly and maintain careful control.
• Practice cutting a few small branches before beginning a major cutting operation.
• Do not attempt to cut branches with diameters larger than 6 in. (15.2 cm).
• Remove lower branches first to allow clear access to higher branches and to provide space for
falling branches.
• Remove long branches in stages, not all at once.
WARNING:
before cleaning or maintaining the unit. Never perform cleaning or maintenance while the
unit is running. Disconnect the spark plug wire to prevent the unit from starting accidentally.
WARNING:
serious personal injury.

MAINTENANCE SCHEDULE

Perform these required maintenance procedures at the frequency stated in the table. These
procedures should also be a part of any seasonal tune-up.
NOTE: Some maintenance procedures may require special tools or skills. If you are unsure about
these procedures, take the unit to an authorized service dealer. Call 1-855-971-1123 for more
information.
NOTE: Maintenance, replacement, or repair of the emission control devices and system may be
performed by an authorized service dealer. Call 1-855-971-1123 for more information.
NOTE: Please read the California/EPA statement that came with the unit for a complete listing of
terms and coverage for the emissions control devices, such as the spark arrestor, muffler,
carburetor, etc.

MAINTENANCE

To avoid serious personal injury, always stop the engine and allow it to cool
Wear protective clothing and observe all safety instructions to prevent
30