Changing Parameters - FEIG Electronic MWD BPC-H Mode D'emploi

EN

5.4 Changing parameters

The adjustment of the motion detector takes place via the connected door controller. The commissioning of the
door controller and the configuration of the parameters can be found in the assembly instructions of the door
controller being used!
The adjustable parameters of the door controller are explained below.
5.4.1 Parameter assignment for the individual motion detectors
The following parameter areas apply to the respective motion detector:
Parameter area L.600-L.6xx = motion detector 1
Parameter area L.700-L.7xx = motion detector 2
Parameter area L.800-L.8xx = motion detector 3
Parameter area L.900-L.9xx = Motion detector 4
5.4.2 Activate support for the motion detectors in the door controller
To be able to use a motion detector with a gate control connected, the interface to the motion detector must be
activated in the gate control. The activation works automatically with factory settings. For this, the respective
parameter L.602, L.702, L.802 or L.902 must be set to 1.
Table 3: Activate support in the door controller
P. [Setting]
range
L.602 0 ... 1
L702
L.802
L.902
FEIG ELECTRONIC GmbH
Comissioning
Function Description/Note
Deactivation This parameter can be used to temporarily deactivate motion
Motion detector detector.
38/74
0: Motion detector inactive
1: Activated
MWD_BPC-H-HU_ver4_Manual_rev0_mul
MWD BPC-H / MWD BPC-HU