General; Validity; Delivery; Type Plate - FEIG Electronic MWD BPC-H Mode D'emploi

MWD BPC-H / MWD BPC-HU
1

General

The transfer or reproduction of this document, as well as the assessment and dissemination of its content are
prohibited unless expressly permitted. Offenders shall be held liable for damages. All patent rights and utility
patent registration rights reserved.

1.1 Validity

This manual is valid as of device software version TST FUxH-SE V03-03.22 and applies to the following
variants:

MWD BPC-H (must not be operated in USA and Canada)

MWD BPC-HU (must only be operated in USA and Canada)

1.2 Delivery

1x Manual
1x Motion detector
1x Bracket
2x Phillips screw
1x Plug M8-Snap-In with termination resistor

1.3 Type plate

Located on the bottom side of the housing (Abb./Fig. 1, Pos.3) is a label that contains information about the type
name, serial number, manufacturer's information, year of production and label.
If the device becomes unusable, dispose it in accordance with the current statutory
regulations!

1.4 Warranty and Disclaimer

The information in this document has been compiled according to the best of our knowledge and belief.
FEIG ELECTRONIC GmbH makes no guarantee for the correctness and completeness of the information in this
document. In particular, FEIG ELECTRONIC GmbH cannot be made liable for consequential damages due to
erroneous or incomplete information.
As errors can never be totally avoided despite all efforts, we are always grateful for any information you could
give us.
The installation recommendations made in this document are based on the most favourable conditions
FEIG ELECTRONIC GmbH accepts no guarantee for faultless operation in extraneous environments.
FEIG ELECTRONIC GmbH makes no guarantee that the information contained in this document is not subject
to foreign property rights FEIG ELECTRONIC GmbH does not assign any licences to its own or third-party
patents or other property rights with this document.
Guarantee claims against FEIG ELECTRONIC GmbH can only be made by the direct contracting party and are
not transferable. Any guarantee only applies to the products supplied by FEIG ELECTRONIC GmbH. Any
liability for the complete system is excluded.
The specification of the products, their use, features and performance data do not count as guaranteed
properties and are subject to technical changes.
FEIG ELECTRONIC GmbH
General
31/74 MWD_BPC-H-HU_ver4_Manual_rev0_mul
EN