Installation; Before Installation; Ambient Conditions; Mounting The Motion Detector - FEIG Electronic MWD BPC-H Mode D'emploi

MWD BPC-H / MWD BPC-HU

4 Installation

4.1 Before installation

The motion detector must be inspected for possible transport or other damage before
CAUTION
installation. Replace a damaged motion detector.
 Under certain circumstances damages to the motion detector can result a danger to
health for the user.
 Electrostatic discharging can result in damage or destruction.

4.2 Ambient conditions

The device is mounted in the centre above the area to be monitored. In doing so, wall and ceiling mounting are
possible. The maximum installation height is 7 m.
Please observe the following before installation:

The device must be mounted so that it is vibration free.

There must be no moving objects in the radiation field in order to avoid spurious detection.

There must not be any fluorescent tubes within the radiation field of the detector.

The radiation fields of two motion detectors must not overlap as this can result in spurious detections.

Do not install behind objects, building elements or covers.

If the motion detector is exposed to rain or snow, it should be set to directional recognition as
precipitation usually falls away from the device and thus does not trigger spurious detection.

If conductive floors are used and the radiation direction is almost vertical, spurious detection can occur
due to reflections.

4.3 Mounting the motion detector

1. Drill holes according to the dimensions on page 5, and attach the bracket with screws.
2. Insert the housing into the mounts on the bracket.
3. Tighten the housing with the screws on the bracket.
Figure 1: Fixing bolt and angle spacing
FEIG ELECTRONIC GmbH
Installation
The angle scale, in 15° divisions, marked
on the case of the motion detector helps with
precise alignment of the device. The maximum
angle is 180°.
35/74 MWD_BPC-H-HU_ver4_Manual_rev0_mul
EN