Operating The Tilting Aid - Drive Stahl Rotec Manuel D'utilisation

Fauteuil roulant standard avec / sans frein à tambor

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Adjusting and removing armrests

When delivered, the armrests are already mounted

to the wheelchair. Depending on your requests, the

armrests can be set as short or long armrests (Picture

18+19). To set, press the spring button in the middle on

the outside of the armrest (picture 20); this can now be

pushed into the desired position.

The spring button must lock into position after

adjustment. Select the next position if necessary!

To fold back the armrest, you must push the lever on

the front of the armrest and pull back the armrest at the

same time. (Picture 21 + 22)

If you want to remove the armrest, you must unlock it as

described, and lift it a little until it can be removed. By

pulling and holding the unlock lever (Picture 23+24) on

the back of the wheelchair, you can remove the whole

armrest.

Extend wheel base

If necessary, the wheel base can be extended by 80

mm. To do so, you must remove both wheels, as well

as the screws attached to the wheel receiver. The wheel

receiver may be turned 180° and mounted a little further

back. Screws should be inserted and tightened. The fi-

xing brake should be adjusted to the new position, as

described in "Adjusting fixing brakes and use". If the

wheelchair is equipped with a hand brake, the brake

plates must be removed prior to extending the wheel

base and installing it after. This adjustment should only

be performed by a specialized dealer. (Picture 25).