Operating The Tilting Aid - Drive Alu Freetec Manuel D'utilisation

28 29
31
33
35
38
30
32
34
36
37
39
Adjusting and removing armrests
When delivered, the armrests are already mounted to
the wheelchair. Depending on your requests, the arm-
rests can be set as short or long armrests (Picture
28+29). To set, press the spring button in the middle
on the outside of the armrest (Picture 30); this can now
be pushed into the desired position.
The spring button must lock into position after
adjustment. Select the next position if necessary.
To fold back the armrest, you must push the lever on
the front of the armrest and pull back the armrest at the
same time (Picture 31+32).
If you want to remove the armrest, you must unlock it
as described, and lift it a little until it can be removed.
By pulling and holding the unlock lever (Picture 33) on
the back of the wheelchair, you can remove the whole
armrest (Picture 34).
Adjusting forerun of the front wheels
Please loosen the bottom two safety screws (Picture 35)
with an allen key in order to adjust the forerun of the
front wheels. After that, the two screws on the eccentric
block must be loosened. The forerun can be adjusted
by turning right or left. (Picture 36).
These changes should only be performed by spe-
cialized dealers!

Operating the tilting aid

To manoevre around kerb stones and over thresholds
step heavily (with the left or right foot) on the tilting aid
whilst simultaneously pushing down the handles. This
ensures that lifting the front of the wheelchair is easier.
Ensure that you are standing securely (Picture 37).
Folding
You can fold this wheelchair with only one pull, for easy
transportation and storage in a car. (Picture 38+39).
To do so, please remove the optional seat cushion and
footrests first, then pull up the straps attached to the seat
– done!
EN
17