Recording Still Images; Video Recording - Polaroid XS20 Manuel D'utilisation

3. Power Button now becomes the Mode Transfer Button and loops through four
distinctive modes. Each time you press the button you can select the following modes:
Mode 1: Manual video recording (Blue LED)
Mode 2: Manual photo-taking (red LED)
Mode 3: Motion-detect video recording (blue and yellow LEDs)
Mode 4: Motion-detect photo-taking (red and yellow LEDs)
4. After each mode is selected, the camera will vibrate once indicating that the mode
has been entered, but be patient. The mode will not ready itself until the LED indicator
lights change from blinking to constant on.

Recording Still Images

1. Power up the camera and set it to the manual photo-taking mode. (See section titled
"Selecting Image-Taking Modes" to select Mode 2.)
2. Press the Execute Button once.
3. Hold the camera still until it shakes once.
4. A photo will be taken immediately after the vibration stops.
5. The red LED will turn off while taking a picture.

Video Recording

1. Power up the camera and set it to the manual video recording mode. (See section
titled "Selecting Image-Taking Modes" to select Mode 1.)
2. In the manual video recording mode, press the Execute Button once. The camera will
shake once and the blue LED flashes slowly indicating that video is being recorded.
3. To stop video recording press the Execute Button again. The blue LED will return to
constant on indicating that recording has stopped and the camera is waiting in its
standby mode.
4. Video recording can occur for a period of 20 minutes at which time the camera will
save the clip and recording will automatically resume in a new file.
motion-Detect Video Recording
1. Power up the camera and set it to the Motion-Detect Video Recording mode. (See
section titled "Selecting Image- Taking Modes" to select Mode 3.)
2. In this mode, the camera will automatically take video clips of moving objects for a
preset length of 10 seconds, 1 minute, 5 minutes or 10 minutes. It will save each clip
in its own file and immediately continue recording another clip of the same length; it
will be saved in its own file, and the process will repeat until you stop the recording
process.
3. If the flash card becomes full, the camera will delete the first recorded clip and
overwrite it with the most current video. This procedure is called "loop recording" and
POLAROID XS20 USER GUIDE
5