Bresser 70-04403 Mode D'emploi page 32

Displaying current indoor and outdoor temperature
1. Slide °C/°F switch (Fig. 1, 10) to change the
temperature unit to Celsius or Fahrenheit.
2. Indoor temperature will be displayed permanently (Fig.
1, 1d). Outdoor temperature can be displayed separately
or automatically for the connected remote sensors (read
more in previous chapter).
Note: Once the channel is assigned to one remote
sensor, you can only change it by pressing the RESET
button (Fig. 2, 25) on the remote sensor. If no signals
are received, "—-" will appear on the LCD. In case of any
fault, relocate the main unit or the remote sensor in other
positions. Make sure both items are within the effective
range of approx. 50 meters. After several trials in vain,
remove the batteries of both items and start set-up again.
Try out where your weather station receives the signals
best, keeping possibly interference sources in mind.
32
Displaying and deleting min./max. temperature values
1. Press MEM- button (Fig. 1, 8) in normal mode to check
the min./max. values for indoor and outdoor temperature
as well as the date/time settings for approx. 5 seconds.
2. Press and hold MEM- button for approx. 3 seconds to
delete the min./max. temperature values.
Note: Once you reset or re-install batteries for the main
unit, all the values will be defaulted.
Ice alert
1. When the outdoor temperature is within the range of
-2°C ~ 3°C (28°F ~ 37°F),
flashing continuously.
2. The icon will disappear when outdoor temperature out
of above temperature range.
will be displayed and is