Bresser 70-04403 Mode D'emploi page 30

difference, the clock will show the time that RC received
time plus/minus the time difference.
Alarm time setting
1. In normal mode, press CLOCK SET button (Fig. 1, 9) to
select alarm mode AL1 or AL2. The selected alarm mode
will be displayed over the desired alarm time.
2. In alarm mode, press and hold ALARM SET button
(Fig. 1, 6) for approx. 2 seconds until the Hour digit is
flashing.
3. Press CH+ (Fig. 1, 7) or MEM- (Fig. 1, 8) to set the
desired value.
4. Press ALARM SET button again move to the minute
setting. Minute digits are flashing. Press CH+ (Fig. 1, 7) or
MEM- (Fig. 1, 8) to move the desired value.
5. Press ALARM SET again to save and exit the setting.
30
Note: The alarm will automatically turn on when you set
the alarm time with the icon
The dual-alarm (AL1 and AL2) design of the main unit will
provide you with more convenience, and you can set two-
alarm times if needed.
Activating alarm
1. Set the alarm time as described in the previous
section.
2. In normal mode, press ALARM SET button (Fig. 1, 6)
once to turn on AL1, press it second time to turn on AL2,
press it third time to turn on both ALM1 and ALM2. The
corresponding icons will be displayed on the LCD. Press
the button again to turn off both alarms. The icons will
disappear.
or displayed.