Reprogramming A Master Tag - SOMFY VsystemPro Manuel D'installation Et D'utilisation

6 REPROGRAMMING A MASTER TAG

If the master tag is lost or damaged, a new one can be programmed using the following
procedure:
[1]. Switch off the power
[2]. Open the external module housing.
[3]. Bridge the PTE and GND terminals or press
and hold down the "press to exit" button, if
this wired to the external module (refer to the
external module's instructions).
[4]. Switch the power back on.
The external module emits a high-pitched "beeping" sound.
[5]. Remove the bridge between the PTE and GND terminals or release the
"press to exit" button.
The external module emits a high-pitched "beeping" sound.
[6]. Place the master tag in front of the tag reader.
The external module emits two high-pitched "beeping" sounds,
then two low-pitched "beeping" sounds, the master tag is
programmed, all user tags have been deprogrammed and the
external module exists programming mode.
[7]. Close the external module's housing.
Copyright © 2016 Somfy SAS. All rights
reserved.
EN
BIP
BIP
BIP BIP
BIP BIP
5