Fill The Water Tank; Fill Coffee Bean Container; Setting The Language; Setting The Water Hardness - Siemens TQ505DF8 Notice D'utilisation

Note: The automatic display for se-
lection of the language and water
hardness only appears when the ap-
pliance is switched on for the first
time.
Tip: You can change the settings at
any time.
→ "Basic settings", Page 61

Fill the water tank

Fill the water tank each day with
fresh, cold, non-carbonated water.
Open the lid.
1.
Remove the water tank using the
2.
recessed grip.
Rinse the water tank.
3.
Fill the water tank up to the "max"
4.
mark.
Insert the water tank into the
5.
holder, keeping it straight.
Close the lid.
6.

Fill coffee bean container

ATTENTION!
Unsuitable beans can block up the
grinder.
Only use pure, roasted bean mixes
▶
that are suitable for use in fully
automatic coffee or espresso ma-
chines.
Do not use glazed coffee beans.
▶
Do not use caramelised coffee
▶
beans.
Do not use coffee beans that have
▶
been treated with additives con-
taining sugar.
Do not add ground coffee.
▶
Open the lid.
1.
Fill with the coffee beans.
2.
The appliance will adjust to the
coffee beans with the next dis-
pensing process.
Close the lid.
3.
Before using for the first time en
Tip: To keep the coffee beans at
their best, store them in a sealed
container in a cool place.
You can keep the coffee beans in the
bean container for a number of days
without them losing their aroma.

Setting the language

Press to switch on the appli-
1.
ance.
a The display will show the language
that is preset.
Press or
2.
shows the desired language.
Press ⁠ .
3.
Tip: You can change the language at
any time.
→ "Overview of the basic settings",
Page 61

Setting the water hardness

It is important to set the water hard-
ness correctly, so that the appliance
indicates in good time that it needs
descaling. You can use the enclosed
test strip to determine the water hard-
ness, or ask your local water com-
pany.
Briefly dip the test strip in fresh tap
1.
water.
Allow the water to drip off the test
2.
strip.
a The test strip will indicate the water
hardness after 1 minute.
If a water softening system is in-
3.
stalled in your house, select
"Softening system".
Press or
4.
shows the desired water hardness.
The table shows the allocation of
the levels to the different degrees
of water hardness:
until the display
until the display
53