Install Electric Built-In Single Oven Or Microwave; Install Coffee System - Jenn-Air W11312047 Mode D'emploi

4. Adjust the trim structure/surface assemblies horizontally to
touch the side surfaces of the mounting jig. Tighten the
hex-head screws at the top of each assembly.
B
A. Mounting jig
B. Trim structure/surface assembly
5. Remove the mounting jig from the cabinet opening. Tighten
the hex-head screws at the bottom of each trim
structure/surface assembly.
A. Trim structure/surface assembly
4
A B
A
Install Electric Built-in Single Oven or
Microwave
1. Using two or more people, push against the seal area of the
front frame to push the oven into the cabinet until the back
surface of the front frame touches the front wall of the
cabinet.
2. Securely fasten oven to cabinet using the screws provided.
Insert the self drilling screws through hole in the side trim
cover. Do not overtighten screws.
3. Follow the oven Installation Instructions to complete
installation.
NOTE: If the built-in oven was not installed into the
cabinet, read the "Electrical Requirements" and "Electrical
Connection" sections, along with all other sections of the
Installation Instructions, before installing the oven.
4. Reconnect power.
5. If the display panel does not light, reference the "Assistance
or Service" section of the Use and Care Guide, or contact
the dealer from whom you purchased your oven.

Install Coffee System

Install the Mounting Brackets
1. Determine where the mounting brackets will be installed and
mark 6 holes through each mounting bracket onto the side
cabinet.
IMPORTANT: The front of the mounting bracket must be
1/16" (2 mm) from the outside of the cabinet frame.
NOTE: To accommodate for flush installation with certain
custom cabinets, align the front of the mounting brackets
13/16" (2.1 cm) back from the front of the cabinet.
A
B
B
A. Front of mounting bracket 1/16" (2 mm)
from outside of cabinet frame
B. Mark 6 screw holes.