Jenn-Air W11312047 Mode D'emploi page 5

2. With the mounting brackets held or taped in place,
measure the distance between the two brackets. (Do not
measure between the runners.) The distance should be
21¹¹⁄zn" (55.1 cm).
NOTE: If the distance between the mounting brackets is
greater than 22" + 1⁄16" (55.9 + 0.07 cm), bracket spacers
will need to be used. Four 1 mm bracket spacers are
included. See Step 3.
3. If bracket spacers are needed: Position the necessary
spacer(s) behind the mounting brackets. Continue with
Step 4.
A
A. Bracket spacers
4. Using a 1/16" (2 mm) drill, drill the holes marked in Step 1.
5. Secure the mounting brackets to the side cabinets with six
3/16" x 5/8" (4.5 x 16 mm) screws in each bracket.
6. Remove the tape holding the brackets in place.
7. Pull the runners forward until they are fully extended and in
the locked position. Place level across the runners and check
levelness. Then place the level along the length of each
runner and check levelness from front to back. If the runners
are not level, uninstall the mounting brackets and raise or
lower the mounting brackets as necessary until they are
level.
A
8. If the coffee system is being installed above a wooden
cabinet bottom, use two 3/16" x 5/8" (4.5 x 16 mm) screws
to install the metal trim piece at the front edge of the cabinet
bottom.
Install the Coffee System
WARNING
Excessive Weight Hazard
Use two or more people to move and install the built-in
coffee system.
Failure to do so can result in back or other injury.
1. Pull the runners forward until they are fully extended and in
the locked position.
2. Using 2 or more people, position the coffee system onto
the runners, making sure that the 4 pins of the L-brackets fit
securely inside the holes on the bottom of the coffee system.
3. Secure the coffee system to the runners with the four
3/16" x 3/8" (4.2 x 9.5 mm) screws.
4. Position the power supply cord clip on the top of the cabinet,
approximately 13ZZ/zn" (34.8 cm) from the front of the cabinet
and centered from left to right. With a pencil, mark the hole
through the clip on the top of the cabinet.
5. Using a 1/16" (2 mm) drill, drill the hole marked in Step 4.
5