ABUS Security-Center eyseo TV7000 Instructions D'installation page 16

5. Power on the camera with the correct
power supply and make sure that the red
Power LED is lit.
6. If there is a video picture visible on the
monitor, you may adjust focus and zoom.
If there is no video picture on the monitor,
please check the following.
• Is the red Power LED of the camera lit?
• Is the monitor powered on and is the level
of contrast and brightness set correctly?
• Is the camera connected properly to the
monitor (also check the resistor settings)?
• Has the lens cover of the lens been
removed?
• Manual iris lenses: is the iris fully open?
• Auto-iris lenses: is the auto-iris connector
connected to the camera and is the lens
drive level fully up?
• Is the illumination where the camera is
located sufficient for this camera model?
7. Mount the camera and align it. Please use
a housing also to protect the camera
against dust. In areas that do not comply
with the specified environment ratings, the
camera has to be installed within a
housing which ensures that the given
environment ratings are observed.
8. Auto-iris connector (7)
To connect an auto-iris lens that requires a
video drive signal, the auto-iris connector is
needed. Apply this connector to the cable of the
lens. The following figure shows the correct
wiring.
Pin
1
2
3
4
Connector
12V DC max.
Video signal
Not used
GND
1
2
16
3
4