TESTO 835 Mode D'emploi page 19

be entered with [
2 Apply the measured or selected value with [
3 Press the trigger to calculate the surface temperature via the IR sensor (T
- The measured value is displayed.
4 Apply the measured value with [
- The calculated emission level (
5 Apply the calculated value with [
8.3 Details: Memory
- The Memory function is opened.
Save - New Location
This function can also be opened directly from the measurement view with [
A new location can be created.
1 Use [ ] to select Save and open the function with [
2 Use [ ] to select New Location and open the function with [
3 Use [ ] and [
4 Use [ ] to select
Save - Save Measurement Data
This function can also be opened directly from the measurement view with [
The current measurement data can be saved in an existing memory location. Only the
individual readings currently shown on the display are stored, no series of measure-
ments!
1 Use [ ] to select Save and open the function with [
2 Select an existing location with [
3 Save the current measurement data with [
Overview
This function can only be opened via settings mode, not with [
measurement view.
Existing memory locations can be displayed and deleted.
Use [ ] to select View and open the function with [
- The existing locations and the volume of measurement data saved there are
displayed.
To delete a location and the saved measurement data: open the function with [
confirm with [ ] (
Delete
This function can only be opened via settings mode, not with [
measurement view.
The entire memory (measuring locations and measurement data) can be deleted.
1 Use [ ] to select Delete and open the function with [
2 Confirm with [
].
].
ε
) is displayed.
].
] to enter a memory location description.
and confirm the entry with [
] and apply this selection with [
) and carry out deletion with [
] ( ) and carry out deletion with [
].
].
].
].
].
].
] from the
].
].
] from the
].
].
8. Settings 19
).
IR
].
].
].
],