Installation And Start-Up - Glatz AURA Instructions D'utilisation Et Options

Installation and start-up

1
5×
2
3
Unpacking the parasol
Supplied with:
- parasol with crank (ready assembled)
- binding
- protective cover
- 5 fastening screws
- 5 support screws
- Allen key
- Operating instructions
!
Dispose of packaging material properly
and keep away from children.
Do not make use of defective material.
In the event of any damage, inform the
transport service provider immediately.
Placing the parasol down
1. Spread out on a woollen blanket.
2. Place the parasol upon it.
i
Carefully place the parasol on a clean,
horizontal surface. The parasol is very
heavy. Work in a threesome and hold
the parasol securely.
Prepare the base
Place the base in accordance with the
separate instructions.
Base weights and wind resistance
minimum maximum
Size base weight wind speed*
[cm] [kg] [km/h (Bft.)]
350 x 350 240 45 (6)
400 x 400 240 40 (6)
* maximum wind speed when it is securely anchored
in the ground.
28 29
4.1
4.6
5.3
2x
5.1
2x
1x
4
Check the standpipe
4.2
1. Turn the locking pin upwards
2. Pull out the stand pipe from the mast
3. Remove any plastic film
4. Position the orientation notch towards
the parasol part
4.4
5. Reinsert the stand pipe
6. Turn the locking pin downwards
7. Lock the standpipe into place.
4.5
!
The orientation notch must face to-
wards the parasol part. Do not remove
the black sliding washer.
5
Preassemble the parasol
1. Place the parasol with the standpipe
on the base
5x
2. Align the cutout/position
3. Insert the washers completely into
the recesses
4. Insert 2 opposite screws and screw
them tight
5.4
!
The parasol is very heavy. Work
in a threesome and hold the parasol
securely.
6
Fixing the parasol in place
6.3
1. Turn the locking pin upwards
2. Carefully turn the parasol
3. Insert 2 further screws and screw
them tight
4. Turn the parasol once more
6.5
5. Insert the last screw and screw it
tight
6. Turn the parasol into the original
position
7. Turn the locking pin downwards