Product Components - Hach CA610 Manuel De L'utilisateur

3.1 Product components

Make sure that all components have been received. Refer to
damaged, contact the manufacturer or a sales representative immediately.
Figure 2 Product components
1 Analyzer
2 Standard solution, 0.5 mg/L as
F-
3.2 Remove the shipping spacer wire
1. Loosen the screws that secure the flow cell assembly. Remove the shipping spacer wire. Refer to
Figure 3.
2. Tighten the screws in small increments and alternate between the screws, so that the flow cell
assembly is moved down evenly. Tighten the screws until the flow cell assembly is seated against
the pump housing. Do not overtighten.
8 English
3 Standard solution, 5.0 mg/L as
F-
4 Reagent solution, TISAB
Figure 2. If any items are missing or
5 Installation, maintenance and
half-cell electrode kits