4-Start-Up And Adjustments; Bssalt Series Equipment; 1- Operation; 2- Messages And Alarms - BSV BSsalt-10 Manuel De L'utilisateur

4- START-UP AND ADJUSTMENTS
Once the BSV salt water chlorinator has been installed, you can start up your
salt water chlorination equipment. Follow the instructions carefully.
The following sections detail the operation of different models.

4.1- BSsalt series equipment

4.1.1- Operation

Using the two P1 and P2 buttons, you can adjust chlorine production.
Excess Salt
Lack of Salt
No water flow
Overload
- P2 increases production and P1 decreases it.
- The green LEDS (LED1 TO LED 5) indicate chlorine production: 0%,
25%, 50%, 75% and 100% of the total.
- Adjustment is stored in the memory, even though the chlorinator is off.

4.1.2- Messages and alarms

The BSsalt series equipment can detect anomalies in the operation of the
system, through the following messages:
- Alarm owing to lack of water flow LED 7
- Alarm for overloading or short circuit: LED 6
- Alarm for open circuit: All power indication LEDs will remain flashing.
- Warning owing to lack of salt.
- Warning owing to excess salt.
You will find further information on the cause of these messages and their
solution in section 4.3. of this manual.
Manual EVO v.3
69 / 142