Adding Salt To The Water - BSV BSsalt-10 Manuel De L'utilisateur

- Ensure that the heatsink wings (in the rear part of the equipment) are
not blocked and that air can easily circulate through them.
- All the BSV equipment incorporate protection systems against short
circuits in the cell, absence of water detector and other safety systems
that give an acoustic and visual alarm in the event of any anomaly.
However, for optimum results, you should ensure the correct hydraulic
operation of your swimming pool.
- Equipment housing has IP65 protection. However, it is highly
recommended not to install the equipment directly exposed to sunlight.
- Corrosive environments may reduce the lifespan of the equipment. Do
not leave open containers with acids near the equipment.
2- PREPARING THE SWIMMING POOL

2.1- Adding salt to the water

To ensure that the chlorinator works correctly, a small amount of salt should be
added and the pH level should be suitable.
The recommended salt and pH levels are the following:
EVoBASIC
EVoLOW SALT
EVoMg
(*) The EVoMg units are designed to work with a mixture of common salt
(NaCl) and magnesium salt (MgCl2). The amount of each kind of salt is defined
as follows: 70% common salt and 30% of magnesium salt.
Although the equipment will start to operate with lower amounts of salt, the
optimum production of salt will be reached with concentrations of over 4kg/m3.
We recommend a concentration of 5Kg/m3 to offset small losses of salt
occurring when cleaning the filter, the effect of rainfall, etc.
To calculate the salt to be added, multiply the total m3 of your swimming pool
x 5.
A swimming pool measuring 9m in length x 4.5m in width x 1.6m in
Example :
depth, using a BSsalt / EVoBASIC
9 x 4.5 x 1.6= 64.8 cubic metres. 64.8 x 5 = 324 Kg of salt to be added.
Manual EVO v.3
Salt Concentration
(g/l)
4 a 6
0,5 a 1
4 a 6 (*)
Ph
7,1 a 7,4
54 / 142