Safety Precautions - Kenwood LZH-70W Mode D'emploi

Safety Precautions

WARNING
To prevent injury and/or fire, take the following precau-
tions:
• Ensure that the unit is securely installed. Otherwise it may fly
out of place during a collision and other jolts.
• When extending the ignition or earth wires, make sure to use
automotive-grade wire or other cables that are 18 gauge
(AWG18) or thicker to prevent wire deterioration and damage
to the wire coating.
• To prevent short circuits, never put or leave any metallic
objects (e.g., coins or metal tools) inside the unit.
• If the unit starts to emit smoke or strange smells, turn off the
power immediately and consult your Kenwood dealer.
• Be careful not to drop the unit or subject it to strong shock—
the unit may break or crack because it contains glass parts.
• Do not touch the liquid crystal fluid if the LCD is damaged or
broken due to shock. The liquid crystal fluid may be danger-
ous to your health or even fatal. If the liquid crystal fluid from
the LCD contacts your body or clothing, wash it off with soap
immediately.
• Do not install the console so that the screen can be seen by
the driver while operating the vehicle.
CAUTION
To prevent damage to the LZH-70W, take the following
precautions:
• Make sure to ground the unit to a negative 12V DC power sup-
ply.
• Do not open the back cover of the unit.
• Do not install the unit in a location exposed to direct sunlight
or excessive heat or humidity. Also avoid places with too much
dust or the possibility of water splashing.
• Do not subject the monitor unit to excessive shock, as it is a
piece of precision equipment.
• When replacing a fuse, only use a new one with the prescribed
rating. Using a fuse with the wrong rating may cause your unit
to malfunction.
• To prevent short circuits when replacing a fuse, first disconnect
the wiring harness.
• Do not use any screws except for the ones provided. The use
of improper screws might result in damage to the unit.
RESETTING THE MICROPROCESSOR
If the unit does not seem to be working properly, turn the vehi-
cle's ignition off, then on again. If that does not solve the prob-
lem, consult your Kenwood dealer.
If you experience problems during installation, consult your
Kenwood dealer.
LZH-70W Instruction Manual
This Product is not installed by the manufacturer of a vehicle on
the production line, nor by the professional importer of a vehicle
into an EU Member State.
Warnings
• Do not use any solvents or cleaning materials when cleaning
the video system.
• Do not use any abrasive cleaners, as they may scratch the
screen. Use only a lightly dampened lint-free cloth to wipe the
screen if it becomes dirty.
• Lock the LCD screen in the fully-closed position when it is not
being used.
• Always adjust the volume setting to the lowest position before
putting on headphones.
• Remember to leave the dome light switch in the OFF or AUTO
position when the vehicle is unattended, as the dome lights
can drain the vehicle's battery if they are left on when the
vehicle is not running.
• Do not apply pressure on the LCD screen.
• Caution children to avoid touching or scratching the screen,
as it may become dirty or damaged.
3