GE IM-6 Manuel D'utilisation Et D'installation page 8
Kit im-6 ce kit convient à la plupart des modèles appelant uk-kit-1, uk-kit-2, uk-kit-4, et à tous les modèles appelant kit im-1, im-2, im-3, im-4 ou im5ss. si vous remplacez une machine à glaçons par un kit im-1 ou im-2, reportez-vous à la page 5.
Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
REMOVE EXISTING ICE TRAY HOLDER
Follow the instructions below for the ice tray holder that looks like yours.
• Unhook the ice tray holder side and bottom from
the retaining hooks. Lower the holder until the side
is clear of the freezer shelf and remove it from the
freezer. You will not need this part.
• As you lift the tab on the left side in the holder with
the blade of a screwdriver, pull the holder forward
and out. You will not need this part.
• When following Instructions G, it is not necessary
to remove the ice tray shelf or, on some models,
the wire shelf next to it.
• Tilt the ice tray shelf and remove it. You will not
need this part.
Installation Instructions
Type 1
Retaining hooks
Type 2
Do not
lift here
Lift this
tab out
Type 3
• Remove the 2 screws and save them for installation
of the icemaker.
• Lift the ice tray holder off the plastic hook. You will
not need this part.
Screws
Plastic hook
• Remove the screw with a 1/4" nutdriver.
• Pull the ice tray shelf away from the wall. Remove
the shelf. You will not need this part.
• Replace the screw.
8
Type 4
Type 5
Screw
Publicité
Table des Matières
