GE IM-6 Manuel D'utilisation Et D'installation page 49

4 CONNECT THE WATER LINE
• Make sure there is enough plastic water line to
extend from the water valve to well into the water
tube inlet (15). Cut off any excess tubing.
• Squeeze the ends of the hose clamp (3) from the
kit with pliers and slide the clamp over the water
tube inlet.
• While still squeezing the clamp, insert the
plastic water line into the inlet as far as it will
go (approximately 1" [25 mm]).
• Then slide the clamp downward to capture the
plastic water line in place.
• Make sure the fill tube is aimed down.
Water tube
inlet
ROUTE AND ATTACH THE
5
PLASTIC WATER LINE
Fasten the plastic water line to the back of the
•
cabinet with adhesive-backed fasteners (5),
spacing the fasteners as shown to take up slack
in the line.
Installation Instructions
3
Adhesive-backed fasteners
for plastic water line
WATER VALVE INSTALLED
6
Refer to the Water Line Installation Instructions
for connection to the home water supply. After
water line installation is completed, set the
icemaker power switch to I (on).
The icemaking cycle will not begin until the icemaker
and freezer compartment reach operating temperature,
then icemaking will begin automatically.
49