GE IM-6 Manuel D'utilisation Et D'installation page 10

ICEMAKER INSTALLATION INSTRUCTIONS C
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator—
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
•
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator
from its electrical outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
PREPARE FOR INSTALLATION
1
• Remove the screw (A) that holds the electrical
plug cover in place. You will not need this screw
and cover.
• Remove the light shield insert (B) and discard it.
• Loosen the two mounting screws (C)
approximately 1/2" (13 mm). DO NOT REMOVE
THESE SCREWS.
C
Installation Instructions
C
Unplug the
Sharp knife
Pliers
B
A
Cover
removed
F G H J K L M
2 INSTALL FILL TUBE EXTENSION
Cut the fill tube extension (10) to the length
(refer to the
C
sharp knife or single-edge razor blade and slide
it onto the fill tube against the stop.
10
C
3
SET POWER SWITCH TO O (off)
Set the icemaker power switch to O (off). Leave
the power switch in the O (off) position until the
refrigerator is connected to the water supply to
prevent premature operation.
Power
Switch
4 POWER CORD ADAPTER
There are two power cord adapters included with the
kit; be sure to use the one specified in the Parts List on
page 7. Plug the female end of the power cord adapter
(19) onto the male terminals on the icemaker power
cord. When connecting the adapter to the power cord,
make sure the seal is in place between the connectors.
Secure the power cord adapter to the icemaker by
putting it into the hook at the back of the icemaker
and attaching it to the icemaker with a wire tie (22).
Hook
10
or S
N P Q R
template on page 67) with a
Hole for
wire tie
Wire tie
C
Seal
Hook