GE IM-6 Manuel D'utilisation Et D'installation page 38

ICEMAKER INSTALLATION INSTRUCTIONS M
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator—
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
•
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator from
its electrical outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
1 INSTALL FILL TUBE
• If the refrigerator already
has a water tube inlet on
the back of the refrigerator,
go to Step 2.
• Cut the fill tube (16) to the
M
length (refer to the
template on page 66)
M
with a sharp knife or
a single-edge razor blade.
• Slide the fill tube (16) onto
the water tube inlet (15).
• Go to the back of the refrigerator. Find the small
label in the upper right hand corner and peel it
off. On the tube side of the water tube inlet (15)
there is an adhesive backing. Remove the adhesive
backing and slide the tube into the hole near the
top at the back of the refrigerator. Firmly press on
the inlet to secure it to the refrigerator.
REMOVE THE OUTLET COVER
2
• Remove the outlet cover
with a flat-blade screwdriver.
Installation Instructions
C
Unplug the
Sharp knife
Pliers
16
15
F G H J K L M
PREPARE FOR INSTALLATION
3
Inside the freezer, loosen the two mounting screws
(B) but do not screw them all the way out. If your
model does not have the screws already in the
freezer wall, look for two plug buttons. Remove the
plug buttons and insert the two Phillips head screws
(14). The screws should extend approximately
1/2" (13mm) out from the freezer wall.
INSTALL FILL TUBE EXTENSION
4
• Remove and discard the white plug from the
upper left corner of the freezer wall.
• Cut the fill tube extension (10) to the
(refer to the
sharp knife or a single-edge razor blade and slide
it onto the fill tube against the stop.
Remove
plug
5
SET POWER SWITCH TO O (off)
Set the icemaker power switch to O (off). Leave
the power switch in the O (off) position until the
refrigerator is connected to the water supply to
prevent premature operation.
Power
Switch
38
or S
N P Q R
B
template on page 67) with a
M
10
M
Hole for
wire tie
M
length