GE IM-6 Manuel D'utilisation Et D'installation page 14

ICEMAKER INSTALLATION INSTRUCTIONS F
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator—
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
•
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator
from its electrical outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
REMOVE PLUG COVER
1
Remove the electric plug cover.
To remove the type shown in Fig. 1,
insert a standard screwdriver blade
in slot at bottom of cover, apply
pressure upwards, and pry cover
away from freezer wall. Discard
this cover.
To remove the type shown in
Fig. 2, press top of cover down
to free its upper tab from slot in
freezer wall. Then pull cover
straight out to free the lower tabs
from their slots. Save this cover
for reinstallation later.
LOOSEN MOUNTING SCREWS
2
Loosen the two mounting screws (A) but do not
screw them all the way out. The screws should
extend approximately 1/2" (13 mm) out from the
freezer wall.
A
Installation Instructions
C
Unplug the
Pliers Sharp knife
Fig. 1
Fig. 2
F G H J K L M
3 INSTALL FILL TUBE EXTENSION
• Remove and discard the white plug from the
upper left corner of the freezer wall.
• Cut the fill tube extension (10) to the
(refer to the
sharp knife or a single-edge razor blade and slide
it onto the fill tube against the stop.
4
SET POWER SWITCH TO O (off)
Set the icemaker power switch to O (off). Leave
the power switch in the O (off) position until the
refrigerator is connected to the water supply to
prevent premature operation.
Power
Switch
5
POWER CORD ADAPTER
There are two power cord adapters included with the
kit; be sure to use the one specified in the Parts List
on page 7. Plug the female end of the power cord
adapter (19) onto the male terminals on the icemaker
power cord. When connecting the adapter to the
power cord, make sure the seal is in place between
the connectors. Secure the power cord adapter to
the icemaker by putting it into the hook at the back
of the icemaker and attaching it to the icemaker
with a wire tie (22).
Hook
14
or S
N P Q R
template on page 67) with a
F
10
Remove
plug
Wire tie
F
length
F
Hole for
wire tie
Seal
Hook