Normal Sounds; Refrigerator Use; Ensuring Proper Air Circulation; Using The Control - Whirlpool EL7ATRRMQ04 Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5. Adjust the legs to level the refrigerator:
Turn the leveling leg to the right to lower that side of the
refrigerator.
Turn the leveling leg to the left to raise that side of the
refrigerator.
6. Check with a level.
7. Open and close the door to make sure it swings properly.

Normal Sounds

Your new refrigerator may make sounds that your old one didn't
make. Because the sounds are new to you, you might be
concerned about them. Most of the new sounds are normal. Hard
surfaces, like the floor, walls, and cabinets, can make the sounds
seem louder. The following describes the kinds of sounds and
what may be making them.
Your refrigerator is designed to run more efficiently to keep
your food items at the desired temperatures and to minimize
energy usage. The high efficiency compressor and fans may
cause your refrigerator to run longer than your old one. You
may also hear a pulsating or high-pitched sound from the
compressor or fans adjusting to optimize performance.
You may hear the evaporator fan motor circulating air through
the refrigerator compartment. The fan speed may increase as
you open the doors or add warm food.
Rattling noises may come from the flow of refrigerant, the
water line, or items stored on top of the refrigerator.
Water dripping on the defrost heater during a defrost cycle
may cause a sizzling sound.
As each cycle ends, you may hear a gurgling sound due to
the refrigerant flowing in your refrigerator.
Contraction and expansion of the inside walls may cause a
popping noise.
You may hear air being forced over the condenser by the
condenser fan.
You may hear water running into the drain pan during the
defrost cycle.
6

REFRIGERATOR USE

Ensuring Proper Air Circulation

In order to ensure proper temperature, you need to permit proper
airflow in the refrigerator. As shown in the illustration, cool air
enters through the refrigerator wall and moves down. The air then
recirculates through the vent near the bottom.
Do not block any of these vents with food packages. If the vents
are blocked, airflow will be prevented, and temperature and
moisture problems may occur
IMPORTANT: To prevent odors and drying out of food, wrap or
cover foods tightly.

Using the Control

Setting the Control
For your convenience, your refrigerator control is preset at the
factory. When you first install your refrigerator, make sure that the
control is still preset to the mid-setting as shown.
NOTE: To turn your refrigerator off, turn the refrigerator control to
the setting shown. Your product will not cool when the
refrigerator control is set to the off position.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

El7atrrmq05El7atrrmq08El7atrrms04El7atrrms05El7atrrms08

Table des Matières