Remote Control (Optional) - Laerdal AED Trainer 2 Mode D'emploi

This function is for future use.
Select one of the 10 standard
scenarios.
Select one of the 3 custom
scenarios.
Show the selected scenario in the operator display
for 2 seconds.
Pause / Resume scenario and AED-Trainer activity.
Pause ( ) will freeze all activity in the trainer.
Pause is indicted by flashing symbol shown.
Resume ( ) resumes the activity from the point at
which it was paused.
Simulate motion artifact. Analysis will be inter-
rupted and a voice prompt asking to stop all
motion will be issued.
Simulate loose electrodes connection
Simulate good electrodes connection. This
function will also override the detection of
physical pad placement.
Simulate a shockable rhythm. This function will
override the running scenario.
Simulate a non-shockable rhythm. This function
will override the running scenario.
Light electrode pad position LEDs on manikin
chest.
Simulate low battery. Press once for Low Battery.
Press again for Replace battery.
Simulate error condition. Unit will stop operation
and give "chirping" sound every 10 seconds. "Er"
is continuously displayed in the operator display.
This state represents a red X in the status display
on the FR2.
Adjust speaker volume.
4
Remote Control
(optional)