Use The Closing Panel; Adjust Or Replace The Flaps - Petsafe Pet Door Guide D'installation

Use the closing panel

The closing panel is useful during inclement weather, or to prevent your pet from using the pet door at certain times.
To use the closing panel, slide it into the grooves at each side of the pet door
frame (L). Pull and release the latch to lock it in place.
To remove, pull the latch and slide the closing panel up and off the pet
door frame.
You can use an additional closing panel (sold separately) on the exterior
frame of the pet door for improved weather resistance.

Adjust or replace the flaps

The pet door's vinyl flaps may shrink or expand due to seasonal weather
changes. Replace or adjust the flaps when necessary for maximum
energy efficiency.
Vinyl flap replacement
1. Remove the flap screws from the top of the pet door frame (N).
2. Remove the vinyl flap and the flap clamp (O). On the exterior frame,
the insulated flap is attached to the flap clamp.
3. Insert the new vinyl flap between the pet door frame and the flap clamp.
The PetSafe logo should be readable on the vinyl flap.
®
4. Reinsert and partially tighten the screws.
5. Adjust the vinyl flap horizontally and vertically so it is centered/centred in the pet door frame and the magnets
on the flap and frame make contact (P).
6. Tighten the screws.
N
Vinyl flap adjustment
1. Slightly loosen the flap screws at the top of the pet door frame (N).
2. Adjust the vinyl flap horizontally and vertically so it is centered/centred in the pet door frame, and the magnets
on the flap and frame make contact (P).
3. Tighten the screws.
8
O
petsafe.com
L
P