Troubleshooting - FUST Novamatic TW 748 E Notice D'utilisation

Sèche-linge
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

69

TROUBLESHOOTING

Problem
You cannot activate the appliance.
The programme does not start.
The appliance door does not close.
The appliance stops during operation.
The display shows a long programme dura-
1)
tion.
The display shows a short programme dura-
tion.
The display shows Err.
The display shows (e.g. E51).
1) After maximum 5 hours, the programme ends automatically
If the drying results are not satisfactory
• The set programme was incorrect.
• The filter is clogged.
• The condenser is clogged.
• There was too much laundry in the
appliance.
Possible solution
Make sure that the mains plug is connected to
the mains socket.
Check fuse in fuse box (domestic installation).
Press Départ/Pause (Start/Pause).
Make sure that the appliance door is closed.
Make sure that the installation of the filter is
correct.
Make sure that the laundry does not catch be-
tween the appliance door and the rubber seal.
Make sure that the water container is empty.
Press Départ/Pause (Start/Pause) to start the
programme again.
Make sure that the weight of the laundry is ap-
plicable to the duration of the programme.
Make sure that the filter is clean.
The laundry is too wet. Spin the laundry in the
washing machine again.
Make sure that the room temperature is not
too warm.
Set the Minuterie (Time Drying) or the Extra
Sec (Extra Dry) programme.
If you want to set a new programme, deacti-
vate and activate the appliance.
Make sure that the options are applicable to
the programme.
Deactivate and activate the appliance. Start a
new programme. If the problem occurs again,
contact the Service.
• The drum is dirty.
• Incorrect setting of the conductivity
sensor.
• The airflow slots are clogged.

Hide quick links:

Publicité

Table des Matières
loading

Table des Matières