Buzzer On/Off; Before First Use; Daily Use - FUST Novamatic TW 748 E Notice D'utilisation

Activating the child lock option:
1. Press the on/off button to activate the
appliance.
2. Wait approximately 8 seconds.
3. Press and hold touchpads (C) and (D)
at the same time. The child lock
indicator comes on.
The child lock indicator comes on.
It is possible to deactivate the
child lock option while a
programme operates. Press and
hold the same touchpads until
the child lock indicator goes off.

Buzzer on/off

To deactivate or activate the acoustic
signals, press and hold for approximately 2
seconds touchpads (B) and (C) at the same
time.

BEFORE FIRST USE

Before you use the appliance for the first
time do these operations:
• Clean the tumble dryer drum with a
moist cloth.
• Start a short programme (e.g. 30
minutes) with moist laundry.

DAILY USE

Start a programme without
delay start
1. Prepare the laundry and load the
appliance.
CAUTION! Make sure that
when you close the door,
the laundry does not catch
between the appliance door
and the rubber seal.
2. Press the on/off button to activate the
appliance.
3. Set the correct programme and options
for the type of load.
Adjustment of the remaining
laundry moisture degree
To change the default degree of the
remaining moisture of the laundry:
1. Press the on/off button to activate the
appliance.
2. Wait approximately 8 seconds.
3. Press and hold buttons (B) and (D) at
the same time.
One of the these indicators comes on:
• the maximum dry laundry
• the more dry laundry
• the standard dry laundry
4. Press the button (F) again and again
until the indicator of the correct level
comes on.
5. To confirm the adjustment, press and
hold buttons (B) and (D) at the same
time for approximately 2 seconds.
At the beginning of drying cycle
(3-5 min.) there could be a
slightly higher sound level. It is
because of start of the
compressor that is normal for
compressor powered
appliances such: refrigerators,
freezers.
The display shows the programme
duration.
4. Press the Départ/Pause (Start/Pause)
touchpad.
The programme starts.
Starting the programme with
delay start
1. Set the correct programme and options
for the type of load.
2. Press the delay start button again and
again until the display shows the delay
time you want to set.
64