Cutting With Nylon Trimmer Line - Maruyama BIG M M23S Manuel De L'utilisateur

Cutting with Nylon Trimmer Line

• The tip of the line does the cutting. The line should stay extended while cutting.
• Do not force the line into the material to be cut. Forcing the line will increase line usage and
cause poor cutting results.
CORRECT
THREE INCHES
(7.5CM) ABOVE
GROUND
Trimming
Hold the bottom of the String Trimmer head about 3 in.
(7.6 cm) above the ground and at an angle. Allow only the
tip of the line to make contact.
Scaling
To remove unwanted vegetation, hold the trimmer head
about 3 in. (7.6 cm) above the ground and at an angle.
Allow the tip of the line to strike the ground, cutting the
vegetation off at the surface.
Mowing
Keep the line parallel to the ground and use a sweeping,
gentle side-to-side motion.
>> CAUTION
• Stop the engine immediately if the cutting head becomes
jammed. Never use a String Trimmer that has a chipped,
cracked or broken cutting head.
• Make certain all moving parts have stopped and disconnect
the spark plug before inspecting the equipment for damage.
INCORRECT
THREE INCHES
(7.5CM) ABOVE
GROUND
15