Using The Remote Control; Auxiliary Mode; Tips On Saving Energy - Sharp AH-XP18UHD Mode D'emploi

USING THE REMOTE CONTROL

LOADING BATTERIES
1
Remove the battery cover.
2
Insert two batteries. (AAA(R03))
Make sure the (+) and (-) polarities are
correctly aligned.
3
Reinstall the battery cover.
4
Press the RESET button using a
thin stick.
NOTE:
• The battery life is approximately 1 year in
normal use.
• When replacing the batteries, always change
both and use the same type.
• If you will not be using the unit for a long time,
remove the batteries from the remote control.
HOW TO USE THE REMOTE CONTROL
Point the remote control towards the
receiver window and press the desired
button. The unit generates a beep when
it receives the signal.
• Make sure nothing, such as curtains, block the
signal receiver window.
• The signal effective distance is 7 m.
CAUTION:
• Do not expose the receiver window to direct
sunlight. This may adversely affect its operation.
• Use of certain fl uorescent lamp in the same
room may interfere with transmission of the
signal.
• Do not leave the remote control in direct
sunlight or near a heater. Protect the remote
control from moisture and shock.
AH-XP18SHV-1 (A889)_EN.indd EN-4 AH-XP18SHV-1 (A889)_EN.indd EN-4
Battery cover
RESET button
Receiver
window
7 m
EN-4

AUXILIARY MODE

Use this mode when the remote control
is not available.
TO TURN ON
Press the AUX button.
• The Green OPERATION lamp (
light up and the unit will start operating in the
AUTO mode.
• The fan speed and temperature setting are
set to AUTO.
TO TURN OFF
Press the AUX button again.
• The Green OPERATION lamp (

TIPS ON SAVING ENERGY

Below are some simple ways to save
energy when you use your air conditioner.
Set the proper temperature
• Setting the temperature lower than necessary
during cooling operation will result in
increased power consumption.
Block direct sunlight and prevent drafts
• Blocking direct sunlight during cooling operation
will reduce power consumption.
• Close the windows and doors during cooling
and heating operations.
Keep fi lter clean to ensure the most
effi cient operation
Disconnect the power cord from the wall
outlet or turn off the circuit breaker when
the unit is not used for an extended
period time
• The indoor unit still consumes a small amount
of power when it is not operating.
) will
) will turn off.
AUX
11/8/2559 BE 2:36 PM 11/8/2559 BE 2:36 PM