Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4. To start the Clean Washer cycle, first enter "Start Operating
Set-up." Then press and hold
the entire display flashing, press
NOTE: The drum will rotate, then the door will unlock,
lock again, and then the cycle will continue.
The washer will not fill, but the drum will rotate while
■
the washer runs a short sensing cycle. This will take
approximately 3 minutes.
5. The cycle will determine whether clothing or other items are
in the washer.
a) If no items are detected in the washer, it will proceed
to Step 7.
b) If any items are detected in the washer, "rL" or "F-34"
will be displayed. Then the door will unlock.
Press
to cancel the failure code. Then repeat steps
COLD
■
1, 3, and 4 to start the cycle again.
6. Once the cycle has begun, allow the cycle to complete.
7. After the cycle is complete, leave the door open slightly,
to allow for better ventilation and drying of washer interior.
Always do the following to maintain washer freshness:
Use only "HE" High Efficiency detergent.
■
Leave the door slightly open after each cycle to allow
■
for better ventilation and drying of washer interior.
Clean the washer monthly using the Washer Maintenance
■
Procedure, and
⁄
cup (160 mL) of liquid chlorine bleach.
2
3
If the procedure does not sufficiently improve the washer
■
freshness, please evaluate your installation and usage
conditions for other causes.
Cleaning the exterior
Use a soft damp cloth or sponge to wipe up any spills.
Occasionally wipe the outside of your washer to keep it looking
new. Use mild soap and water. Do not use abrasive products.
Cleaning the dispenser drawer
The dispenser drawer is removable for easy cleaning.
1. Unlock the dispenser drawer by pressing the Release Lever.
Remove the drawer.
2. Remove the inserts (the siphon from the softener and bleach
compartments).
3. Wash the parts under running water.
NOTE: Do not wash components in the dishwasher.
4. Re-install the inserts and return the dispenser to the drawer.
Water Inlet Hoses
Replace water inlet hoses after 5 years of use to reduce the risk of
hose failure. Periodically inspect and replace water inlet hoses if
bulges, kinks, cuts, wear, or leaks are found.
When replacing your water inlet hoses, mark the date of
replacement on the label with a permanent marker.
for 1 second. With
COLD
.
COLORS/DELICATES
ALTERNATE PARTS &
ACCESSORIES
Alternate Parts
Your installation may require additional parts. If you are interested in
purchasing one of the items listed here, call the toll-free number on
the back cover of this Use and Care Guide.
If you have
Laundry tub or standpipe
taller than 96" (2.4 m)
Overhead sewer
Floor drain
Drain hose too short
Water faucets beyond
reach of fill hoses
Accessories
Enhance your washer with these premium accessories.
For more high-quality items or to order, call the toll-free number on
the back cover of this Use and Care Guide
Part Number
Accessory
8212526
Washer drip trays, fits under all
31682
All purpose appliance cleaner
1903WH
Laundry supply storage cart
Pedestal
You have the option of purchasing pedestals separately for this
washer. The pedestal will add to the total height of the washer.
Optional pedestal
Pedestal
Approximate height
Height
with washer
2
⁄
" (73 mm)
47.5" (1207 mm)
7
8
You will need to buy
Sump pump system (if not already
available)
Standard 20 gal. (76 L), 30"
(762 mm) tall drain tub or utility sink
and sump pump (available from
local plumbing suppliers)
Siphon break, Part Number 285834;
additional drain hose,
Part Number 8318155; and connector
kit, Part Number 285835
4 ft (1.2 m) drain hose extension kit,
Part Number 285863
2 longer water fill hoses:
6 ft (1.8 m) Part Number 76314
10 ft (3.0 m) Part Number 350008
Options
Color
Part Number
White
WHP0400VW
13
Publicité
Table des Matières
