Air Filter Maintenance; Change Oil; Safety Recommendations; Maintenance Schedule - GGP ITALY WM Série Manuel D'utilisation

Table des Matières

Les langues disponibles

6. MAINTENANCE

6.1

SAFETY RECOMMENDATIONS

WARNING!

cap and read instructions before carrying

out any cleaning, repair or maintenance

operation. Wear proper clothing and work-

ing gloves whenever your hands are at risk.

Do not perform maintenance or repair

operations without the necessary tools and

technical knowledge.

IMPORTANT

Never get rid of used oil, fuel

or other pollutants in unauthorised places.

6.2

MAINTENANCE SCHEDULE

Follow the hourly or calendar – whichever occur

first – maintenance schedule shown in the fol-

lowing table.

Operation

Check oil level

(see 5.1.1)

Change oil

(see 6.3)

Clean silencer and

engine (see 6.4)

Air filter cleaning

and check (see 6.5)

Air filter replacement

(see 6.5)

Check spark plug

(see 6.6)

Replace spark plug

(see 6.6)

Fuel filter check

Change oil every 25 hours if the engine is oper-

ating under heavy load or in ht weather.

Clean air cleaner more frequently if the

machine is operating in dusty areas.

To be carried out by a specialized Centre.

Remove the spark plug

6.3

CHANGE OIL

See the specific chapter (8.1) for the oil to be

used.

WARNING!

is warm, being careful not to touch the hot

engine nor the drained oil.

Unless otherwise stated in this machine Instruc-

tion Manual, to drain the oil it is necessary to:

a) Place the machine on a flat surface.

b) Clean the area around the filler cap and

unscrew the cap with dipstick (1).

c) Provide a suitable container for collecting the

oil and unscrew the drain plug (2).

d) Refit the drain plug (2) and fully tighten it hav-

ing made sure that the gasket is in the right

position.

e) Fill up with fresh oil (see 5.1.1).

f) Check that the oil level has reached the

«MAX» notch on the dipstick (3).

g) Close the cap (1) again and clean up any

traces of oil that was possibly spilt.

IMPORTANT

mum of 1.2 litres of oil. Topup gradually adding

small amounts of oil at a time; check that the oil

level never exceeds the «MAX» notch on the

dipstick.

6.4

CLEAN SILENCER AND ENGINE

Silencer must be cleaned when the engine is

cold.

a) Use a jet of compressed air to remove any

debris and dirt that could cause a fire from

the silencer and its protective cover.

b) Make sure that the cooling air intakes (1) are

not blocked.

c) Clean the plastic components with a sponge

(2) soaked in water and detergent.

6.5