Battery Replacement - Alecto WS-1050 Mode D'emploi

• De transmission range can be affected
by nearby devices transmitting on
433.92 MHz.
• The range also depends on obstacles.
Concrete walls between the outdoor and
indoor unit will reduce the transmission
range more than plaster walls.
Rechargeable batteries:
You can choose to use normal (alkaline) or
rechargeable batteries in both the indoor and
outdoor unit. However, rechargeable batteries
provide a lower voltage, reducing the lifespan
and accuracy of the WS-1050. Rechargeable
batteries must be charged using an external
charger.

BATTERY REPLACEMENT

Indoor unit:
After replacing the batteries of the indoor unit,
all memories and settings will be deleted.
Outdoor unit:
After replacing the batteries of the outdoor
unit, you'll need to re-register it to the indoor
unit.
To do this, follow the instructions of chapter
'Installation'.
Always make sure to set the same channel
number on the indoor and outdoor unit using
the "CH" button.
RESET/SYSTEM ERROR
If the WS-1050 shows a possible error, you
may have to reset the indoor and outdoor
unit.
1. Remove the batteries from the indoor and
outdoor unit.
2. Wait for at least 10 seconds and then
replace the batteries.
3. Follow the registration procedure (see
paragraph 'Installation').
After several seconds the indoor and outdoor
unit will have recognised each other and you
can start using the WS-1050 again.
If you still have no connection or sound,
please contact the customer service of
Alecto.
EUENVIRONMENT
At the end of its lifespan, this product should
not be discarded as normal domestic waste,
but is must be taken to a collection point
for the recycling of electric and electronic
equipment.
Don't throw away exhausted batteries, take
them to your local depot for small chemical
waste.
12