Dismantle The Brush Wiper 2 - Festo DG GA Série Notice D'utilisation

DG..−...−GA, FDG−...−GA, DMES−...−GA
Clean the slide 4 and the cover profile
1 (see chap. Care and maintenance").
Remove the support screws 3.
Dismantle the brush wiper 2.
Pull out the cover profile 1.
Fit the shock absorber support type
KYP−... in accordance with the operat
ing instructions.
When refitting:
Fit the cover profile as follows:
S
Push in the cover profile 1.
Tighten the support screws 3.
Fit the brush wiper 2 (tightening torque see Fig. 9).
Using shock absorbers directly in the profile support 6:
Use only the assembly kit in accordance
S
with the chapter Accessories".
Only this contains the screw−in elements
for the correct fitting of the shock absorber.
5 Commissioning
Please note
Protected guides which have already been fitted at the factory do not require
subsequent adjustment.
S Do not modify the settings of screws and adjusting elements if there is no
direct request to do this in these operating instructions.
Remove the cover devices from the slide
S
surface intended for fastening the load as
follows:

Dismantle the brush wiper 2.

Push out the groove cover aJ.
Fit the brush wiper again
Lift out the cover caps 9
(only if holes are required).
12
1
Fig. 7
Fig. 8
9
4 Nm
aJ
0.6 Nm
Fig. 9
Festo DG..−...−GA, FDG−...−GA, DMES−...−GA 0503a English
4
2
3
6
2
4 Nm