Vent-Axia Lo-Carbon Svara Manuel D'installation Et D'utilisation page 5

EN
• Mark the three attachment points for the appropriate
screws to the substrate (Figure J). Tighten the screws so
that gasket seals against the wall.
J.
Always use a qualified electrician
All electrical connections 100-240V must be performed by a
qualified electrician. Any electrical work on the product must
utilise a voltage break.
Electrical connection can be made according to the wiring
diagram on page 6-7 and the fan is suitable for connection
to either 100-240VAc or 12VDC.
NOTE:
The internal cable route must be as indicated as
figures K/K1 (240VAC) and L (12VDC) to prevent the cable
blocking the locator's for the motor assembly.
Operating and installation instructions
K.
100-240 V AC
connection
K1.
L.
12 V DC connection
Installer information
5