6 1 Remoset Function; 6 2 Setting The Frequency Manually - Monacor JTS JSS-20/5 Mode D'emploi

3.6.1 REMOSET function
For the REMOSET function always make sure
that
1 no menu is called up on the microphone or
on the receiver
2 the microphone is switched on and close to
the receiver (REMOSET transmission range:
approx 10 m)
3 the microphone and the receiver are set to
the same identification number (ID No ) or
that the function ID No is deactivated (see
paragraph "Identification number")
4 the REMOSET function is not disabled (see
paragraph "Disabling the REMOSET func­
tion")
5 the receiver and the microphone are not
locked (chapter 3 11)
6 the microphone is not muted (chapter 3 10)
– Identification number –
To prevent mutual interference of individual
pairs of microphone/receiver during REMOSET
transmission, each pair must have a different
identification number (ID No ) If you only use
one pair of microphone/receiver, there is no
need to change the preset ID No 1 To change
the ID No :
1) Call up the setting for the ID No via the menu
item
5. Device ID
Device ID
1
ID : ON
2) Press the button  or  to set the ID No
3) Press the button SET Then press the button
 to deactivate the function (OFF) or the
button  to activate the function (ON) If the
function has been deactivated, the REMOSET
transmission will be possible from any UF­
20R / 5 or UF­20S / 5 receiver; if the function
has been activated, the REMOSET transmis­
sion will only be possible from a receiver with
the same ID No
4) Press the button SET to save the setting
16
of the main menu
Fig. 8
– REMOSET transmission –
Press the button REMOSET on the receiver As
soon as the microphone has been set to the
transmission frequency or to the group and the
transmission channel of the receiver, the LED (3)
shows blue for five seconds and the display in­
dicates
Sync...
If the LED does not show blue, the auto­
matic synchronization of the microphone has
failed In this case, the button REMOSET on
the receiver keeps flashing slowly For trouble­
shooting see steps 1 – 6 at the beginning of this
chapter Check the settings on the microphone
and possibly on the receiver and correct them
Then press the button REMOSET on the receiver
again
– Disabling the REMOSET function –
The REMOSET function can be disabled to pre­
vent automatic setting:
1) Call up the menu item
main menu
Remoset
ON
OFF
2) Press the button  to disable the func­
tion (OFF) or the button  to enable the
function (ON)
3) Press the button SET to save the setting
3.6.2 Setting the frequency manually
1) Call up the frequency setting via the menu
item
1. Frequency
Frequency
532.625
G: 1 C: 1
2) Press the button  or  to set the frequency
in steps of 1 MHz
3) Press the button SET so that the digits after
the decimal point are highlighted To make a
fine adjustment in steps of 0 025 MHz, press
the button  or  If the frequency is identi­
cal to the frequency of a channel in a group,
the group and channel numbers are indicated
in the lower line
4) Press the button SET a second time to save
the frequency selected
in the
6. Remoset
Fig. 9
of the main menu
Fig. 10